Description Qty Item Price  
your basket is empty

sub total£0.00  
£ $
proceed to checkout

Introduction to Design for Injection Moulding 

Special Discounted Rate for February : £99


Defective plastic parts are often only found late in the day and after significant investment of time and money. By attending this one-day course you will gain an understanding of the causes of part defects and how to avoid them. Common plastic part defects will be explored and solutions developed, enabling attendees to design plastic parts with confidence. Wilde are offering a special discounted rate for this course in February.

Event Details

Start Date/Time: 03 Feb 09:00
End Date/Time: 03 Feb 17:00

This course will also introduce the application of Finite Element Analysis (FEA) tools to identify issues early in the design cycle.


Who Should Attend?

This course is aimed at all designers and engineers involved with injection moulded parts. Toolmakers and technicians looking to increase their understanding of the injection moulding process will also benefit from attending this course.

Agenda

  • Course Introduction
  • Course objectives
  • The injection moulding process
  • Common part defects (including warpage, sink marks, weld lines, air traps and voids)
  • Plastic Flow in Injection Moulding
  • Flow behaviour
  • Heat balance in the injection mould
  • Pressure and shrinkage
  • Materials and fibre reinforcement
  • Causes of Warpage
  • Why do plastic parts warp?
  • The influence of part design
  • Tool design
  • Processing conditions
  • Tooling Considerations
  • Gate placement and sizing
  • Hot and cold runners
  • Ejection and venting
  • FEA and Simulation
  • Flow prediction
  • Warpage and distortion
  • Failures in Service
  • Residual stresses
  • Mechanical properties and shear degradation
  • Creep


Location

Romi Machines UK Limited
Leigh Road
Swift Valley Industrial Estate
Rugby
CV21 1DS

Course Fee

Introduction to Design for Injection Moulding- 3rd February: £99
Usual Course Fee: £350

Availability on this course is limited, so please register now to secure your place.


Further Information

For further information, please visit: wildeanalysis.co.uk/events/2016/design-for-injection-moulding-introduction

Alternatively, please contact us on 0161 474 7479 or email events@wildeanalysis.co.uk


Details

Event Type: Seminar
Location: Stockport UK
Date: February 3, 2016